Projector Lamp Maintenance
131
c
Use the screwdriver included with the replacement lamp to loosen the
screw securing the lamp cover.
Warning
When replacing the lamp, there is a possibility that the lamp may be
broken. If replacing the lamp of a projector which has been installed on the
ceiling, you should always assume that the lamp is cracked, and you should
stand to the side of the lamp cover, not underneath it. Remove the lamp
cover gently. Be careful when removing the lamp cover as shards of glass
may fall out and could cause an injury. If any shards of glass get into your
eyes or mouth, contact a doctor immediately.
d
Slide the lamp cover out and lift it off.
e
Loosen the screws securing the lamp to the projector. The screws do
not come all the way out.
To Next Page
Loading...
Need help?
General
