Because the image is slightly enlarged, the protruding area is cropped.
Solutions
Select a smaller enlargement setting.
❏ Copying Photos
Select Various Prints > Various c opies > Copy/Restore Photos > Border Setting > Borderlesson the
control panel and then change Expansion setting.
❏ Borderless Copying
Select Various Prints > Various c opies > Borderless Copy > Advanced Settings > Expansion on the
control panel, and then change the setting.
& “Copying Without Margins” on page 109
The Position, Size, or Margins of the Copies are Incorrect
e following causes can be considered.
The paper is loaded incorrectly.
Solutions
Load paper in the correct direction, and slide the edge guide against the edge of the paper.
& “Loading Paper” on page 34
The originals are not placed correctly.
Solutions
❏ Make sure the original is placed correctly against the alignment marks.
❏ If the edge of the scanned image is missing, move the original slightly away from the edge of the
scanner glass.
& “Placing Originals” on page 39
There is some dust or stains on the scanner glass.
Solutions
Clean the scanner glass and the document cover using a dry, so, clean cloth. If there is dust or stains
around the originals on the glass, the copy area may extend to include the dust or stains, resulting in the
wrong copying position or small images.
& “Cleaning the Scanner Glass” on page 139
Solving Problems
>
Printing, Copying, and Scanning Quality is Poor
>
Copy Quality is Poor
223
To Next Page
Loading...
