On
Return to the On-line State
Applies to asynchronous operation only. If the user enters the command mode from
the data mode by issuing the escape sequence, or as a result of ON-to-OFF transi-
tion of DTR with the AT&D1 option in effect, the user may return to the data mode
without terminating a call by issuing the ATO command.
O0
Causes the modem to return to the data mode. (default)
O1
Enters on-line data mode with a retrain before returning
to on-line data mode.
P
Set Pulse Dial as Default
Causes the modem to assume that all subsequent dial commands are pulse dialed.
You may omit the “P’ from the dial strings.
Q
Result Code Display
Determines whether the modem sends the result codes to the DTE.
Q0
Allows the modem to send result codes to the
DTE. (default)
Q1
Prohibits the modem from sending result codes
to the DTE.
2 - COMMAND REFERENCE
9
To Next Page
Loading...
