“H0
Disables V.42 bis.
“H1
Enables V.42 bis only when transmitting data.
“H2
Enables V.42 bis only when receiving data.
“H3
Enables V.42 bis for both transmitting and
receiving data. (default)
“On
V.42 bis String Length
This command specifies the maximum number of characters that can be com-
pressed into one V.42 bis code word. The default value of 16 optimizes throughput
for most file types.
n=6-250=Number of characters
2.3
Dial Modifers
This section describes all of the dial modifiers which are used in dial strings.
@
Wait for Quiet Answer
Cause the modem to wait for specified amount of time (S-register
S7) followed by 5 seconds of silence before processing the next
dial modifier.
26
COMMAND REFERENCE - 2
To Next Page
Loading...
