Epson ESC/VP21 - Commands Preceded by &

The partial connect message reports CONNECT, the full message reports CON-
NECT XXXX, where XXXX is the data rate.
Yn
Enables or Disables Long Space Disconnect
Y0 Disables Long Space Disconnect.
Y1
Enables Long Space Disconnect.
(default)
Zn Reset
Zn, which must be placed at the end of the command line, resets the active configu-
ration of the modem to the stored configuration saved in nonvolatile RAM, hanngs
up the modem. and clears the command buffer.
Z0 Resets the modem and loads stored
configuration 0. (default)
Z1 Resets the modem and loads stored
configuration 1.
2.2.a Commands Preceded by &
&Cn Select DCD Options
&C0 Maintains an ON status for the Data Carrier
Detect. (DCD)
&C1
Uses the actual state of the carrier from the
remote modem for DCD. (default)
2 - COMMAND REFERENCE
11