48 Fine-Tuning the Projector
■ Tracking
Adjust this value to eliminate vertical stripes in computer
images.
■ Sync
Adjust this value if computer images appear blurry or flicker.
■ Position
If the image is slightly cut off on one or more sides, it may not
be centered exactly. Select this setting and use the arrow
buttons to center it.
■ Progressive
For composite video, S-Video, and component video. Turn
this setting on to convert interlaced signals into progressive
signals (best for moving images). Leave the setting
Off for still
images.
■ Input Signal
If the colors don’t look right on the Auto setting, select the
setting for the type of equipment you’ve connected to the
Computer (Component Video) port. Choose RGB for a
computer or RGB-video connection, or
Auto for a video
player that outputs a component video signal (with
connectors labeled Y/Cb/Cr or Y/Pb/Pr).
■ Video Signal (composite or S-Video signals only)
Select the setting for the type of equipment you’ve connected
to the
Video port. Leave this setting at Auto unless you are
using a 60-Hz PAL system (then select
PAL60).
■ Aspect
Sets the image’s aspect ratio (ratio of width to height). See
page 35 for more information.
note
You can also use the remote
control’s
Auto button to
automatically reset the
rojector’s Tracking, Sync,
and Position settings. See
age 75 for details.
note
You can adjust the
Progressive setting for
signals from component
video only when
480i/576i/1080i signals are
being input.
To Next Page
Loading...
Need help?
Projection
Power
Weight and Dimensions
