Epson EX31 User Manual

84 Maintaining the Projector
5. Hold the lamp as shown and pull it straight out.
6. Gently insert the new lamp. (If it doesn’t fit easily, make sure it is
facing the right way.) Then tighten its screws.
7. Replace the lamp cover, then tighten its screw.
8. Reset the lamp timer as described in the next section.
note
The lamp(s) in this
product contain mercury.
Please consult your state and
local regulations regarding
disposal or recycling. Do not
put in the trash.
note
Tighten the lamp cover
securely so you do not receive
a lamp cover error when you
turn the projector back on.

Epson EX31 Specifications

Projection System

projection system	Epson 3LCD, 3-chip technology
projection method	Front/rear/ceiling mount
driving method	Epson Poly-silicon TFT Active Matrix

Display Performance

white light output	2500 lumens
color light output	2500 lumens
native resolution	800 x 600 (SVGA)

Power and Consumption

power supply voltage	100 – 240 V ±10%, 50/60 Hz
power consumption	280 W, 0.3 W standby
lamp type	200 W UHE

Operating Environment

operating temperature	41 ˚ to 95 ˚F (5 ˚ to 35 ˚C)
fan noise (normal mode)	34 dB
fan noise (eco mode)	29 dB

Dimensions and Weight

dimensions including feet	11.6" x 9.0" x 3.1"
dimensions excluding feet	11.6" x 9.0" x 3.0"
weight	5.1 lb