Epson EX7210 User Manual

• Do not place the projector where the cord can be walked on. This may result in fraying or damage to
the plug.
• Unplug the projector from the wall outlet before cleaning. Use a dry cloth (or, for stubborn dirt or
stains, a moist cloth that has been wrung dry) for cleaning. Do not use liquid or aerosol cleaners.
• Do not block the slots and openings in the projector case. They provide ventilation and prevent the
projector from overheating. Do not operate the projector on a sofa, rug, or other soft surface, or set it
on top of loose papers, which could block vents underneath the projector. If you are setting up the
projector near a wall, leave at least 7.9 inches (20 cm) of space between the wall and the air exhaust
vent.
• Do not operate the projector in a closed-in cabinet unless proper ventilation is provided.
• Never push objects of any kind through the cabinet slots. Never spill liquid of any kind into the
projector.
• If you are using two or more projectors side-by-side, leave at least 2 feet (60 cm) of space between the
projectors to allow for proper ventilation.
• You may need to clean the air filter and vent. A clogged air filter or vent can block ventilation needed
to cool the projector. Do not use canned air, or the gases may leave a residue.
• Do not store the projector outdoors for an extended length of time.
• Except as specifically explained in this manual, do not attempt to service this product yourself. Refer
all servicing to qualified personnel. Opening or removing covers may expose you to dangerous
voltages and other hazards.
• Never open any covers on the projector except as specifically explained in this manual. Never attempt
to disassemble or modify the projector. Refer all repairs to qualified service personnel.
• Unplug the projector from the wall outlet and refer servicing to qualified service personnel under the
following conditions: if it does not operate normally when you follow the operating instructions, or
exhibits a distinct change in performance; if smoke, strange odors, or strange noises come from the
projector; if the power cord or plug is damaged or frayed; if liquid or foreign objects get inside the
projector, or if it has been exposed to rain or water; if it has been dropped or the housing has been
damaged.
• Do not touch the plug during an electrical storm. Otherwise, you may receive an electric shock.
• Unplug the projector when it will not be used for extended periods.
• Do not use the projector where it may be exposed to rain, water, or excessive humidity.
• Do not use the projector where it may be exposed to smoke, corrosive gases, or excessive dust.
• Do not use or store the projector or remote control in a hot location, such as near a heater, in direct
sunlight, or in a closed vehicle.
126

Epson EX7210 Specifications

Projection Specifications

projection_system	3LCD, 3-chip technology
projection_method	Front/rear/ceiling mount
native_resolution	1280 x 800 (WXGA)

Light and Lamp

color_light_output	2800 lumens
white_light_output	2800 lumens
lamp_type	200 W UHE

Power

power_supply_voltage	100 – 240 V ±10%, 50/60 Hz
power_consumption_eco_mode	234 W
power_consumption_normal_mode	283 W

Operating Environment

operating_temperature	41 ˚ to 95 ˚F (5 ˚ to 35 ˚C)
fan_noise_eco_mode	29 dB
fan_noise_normal_mode	37 dB

Lens

f_number	1.58 - 1.72
focal_length	16.9 mm – 20.28 mm
zoom_ratio	Digital zoom 1.0 – 1.2

Weight and Dimensions

dimensions_excluding_feet	11.6" x 9.0" x 3.0"
dimensions_including_feet	11.6" x 9.0" x 3.1"
weight	5.1 lb