Epson IM-800 - Connecting the AC Cable

IM-800 User’s Manual 7
English
Setup
Setting the AC Voltage
If you are using 100-127 V power, set the AC voltage switch to 115.
If you are using 200-240 V power, set the AC voltage switch to 230.
(The factory setting is 230.) If the setting is wrong, the system will
be damaged and will not operate.
Follow these steps:
1. Remove the warning sheet.
2. Set the AC voltage switch.
Connecting to the DM-M820
The DM-M820 has two types of cables. Connect these cables
correctly after unplugging the AC cable.
Four cable type of DM-M820 (with touch panel and/or MSR)
❏
DC plug Connect to the DC 12V output of the
IM-800.
❏
Video connector Connect to the CRT port of the IM-800.
❏
Serial port connector Connect to the COM port of the IM-800
for the touch panel.
❏
Keyboard-Out Connect to the keyboard port of the
IM-800.
❏
Keyboard-In When connecting an external keyboard,
connect it to this cable.
Two cable type of DM-M820 (with no touch panel and no MSR)
❏
DC plug Connect to the DC 12V output of the
IM-800.
❏
Video connector Connect to the CRT port of the IM-800.
CAUTION:
Connect the DC plug of the DM-M820 to the IM-800 before the IM-800 is
turned on. If the DC plug of the DM-M820 is connected to the IM-800
after it is turned on, the DM-M820 may be damaged.
Connecting the AC Cable
When AC power is supplied, a minute electric current flows
through the IM-800. Therefore, when connecting peripherals and
cables to this product, unplug the AC cord first.