Epson IM-800 - Opening and Closing of the CD;FDD Cover

10 IM-800 User’s Manual
English
These LEDs have the following meanings:
Opening and Closing of the CD/FDD Cover
When opening the CD/FDD cover, push down the top of the CD/
FDD cover as shown in illustration I.
Inserting and Removing a CD-ROM
1. Press the eject button of the CD-ROM drive; the tray comes out.
2. Put the CD-ROM with the label side up in the tray.
CAUTION:
Push the CD-ROM down slightly to ensure that it is firmly set in the
tray. Otherwise the CD-ROM may be damaged.
3. Gently push the tray into the CD-ROM drive. See illustration J.
To remove a CD-ROM, follow these steps.
1. Check that the access LED of the CD-ROM is off.
2. Press the eject button; the tray comes out slightly.
3. Pull the tray out fully and remove the CD-ROM carefully.
CD-ROM Emergency Ejection
When the CD-ROM drive does not function properly, you can
remove the CD-ROM by following the steps below:
1. Turn off the IM-800.
2. Insert a small, thin object, such as an extended paper clip, in the
CD-ROM eject hole. See illustration K.
3. The disk tray pops out slightly; then pull it out gently.
LED Color Meaning
ACT Yellow Accessing the network (Transmitting and receiving)
100 Green Connected to 100Base-TX