Epson l300 - Running a Product Check

Light status Condition/solution
The ink pads are near the end of their service life. Contact Epson for
The power light is on or
support.
flashing
The ink light is flashing
The paper light is flashing
An error has occurred during firmware updating. Connect your product
The ink light is on
using a USB cable and try updating the firmware again. If the error
The paper light is on
message continues, contact Epson for support.
A fatal error has occurred. Turn the product off and then back on again.
The power light is flashing
If the error continues, check for a paper jam. If the error persists,
The ink light is flashing
contact Epson for support.
The paper light is flashing
Parent topic: Solving Problems
Related references
Paper Jam Problems
Where to Get Help
Related tasks
Refilling the Ink Tanks
Related topics
Loading Paper
Running a Product Check
Running a product check helps you determine if your product is operating properly.
1. Press the power button to turn the product off.
2. Disconnect any interface cables connected to your product.
3. Load plain paper in the product.
4. Hold down the stop button and press the power button to turn the product on.
5. When the product turns on, release both buttons.
The product begins printing a nozzle check pattern.
82