144
5. Select Head Cleaning and press the OK button.
6. Press the start button to clean the print head.
Caution: Never open the inner cover or turn off the product during a cleaning cycle or you may
damage it.
You see a message on the LCD screen and the power light flashes throughout the cleaning cycle.
When the cleaning cycle is finished, the power light stays on and you see a message on the LCD
screen.
7. Select Nozzle Check, press the OK button, and press the start button to run a nozzle check and
confirm that the print head is clean.
If you don’t see any improvement after cleaning the print head up to 3 times, turn off the product and wait
at least 12 hours. Then run a nozzle check and try cleaning the print head again. If quality still does not
improve, run a Power Cleaning. If there is still no improvement, contact Epson support.
Parent topic: Print Head Cleaning
Related references
Where to Get Help
Related tasks
Checking the Nozzles Using the Product Control Panel
Refilling the Ink Tanks
To Next Page
Loading...
