Start Here
Continued Continued on back
Unpacking
Assembling the Printer
Connecting the Power Cord
Connecting the Printer to Your Computer
1
It may come attached to the printer in some countries.
The shape of the plug may vary by location.
2
Pull upright and push firmly
Attach
Attach
Make sure that all of the
protective materials in the
printer are removed
Remove
Open
Remove
Push and
hold up
Do not touch the white cable
inside the printer
Confirm the print head is in the middleRemove the paper tension unit
Tense the ribbon
Continuous multipart
forms
Other paper
Hook and push
Attach
Close
Attach the paper tension unit
See the
Troubleshooting
section in the User’s
Guide for details
Attach
Insert the ribbon
between the print
head and carriage
Insert until it clicks
Tense
c
Caution:
Do not insert the ribbon on the far
side of the carriage.
<correct><incorrect>
carriage
3
Confirm the (OFF)
Connect
Plug in
4
c
Caution:
❏ The interface cable connectors have only one correct orientation. Make sure the orientation of the connector is correct
before inserting it into the appropriate port.
❏ Do not connect or disconnect the printer while it is turning on.
USB
Connect firmly
Connect firmly
To Next Page
Need help?
General
