1
Locate the required cables:
2
Connect the computer cable to
the blue Computer/Component Video
port on the projector.
3
Connect the other end to your notebook’s video-out
or monitor port.
NOTE: If your notebook has a DVI connector, you need to use an
optional DVI-to-VGA adapter with the included computer cable
(see your computer’s documentation).
4
Connect the power cord to the
projector, then plug the other end
into an electrical outlet.
1
Turn on your notebook.
2
Open the A/V Mute slide.
NOTE: The slide must be
opened completly.
3
Make sure the Power light
is orange and not flashing.
4
Press the Power button
to turn on the projector.
Turn on your equipment
Connect the projector
to your notebook
Follow these instructions to connect the projector to your
notebook. For other setup options, see your User’s Guide.
Epson
®
PowerLite
®
1700c/1710c
Quick Setup
Power cord VGA computer cable
1
If you’ve turned on your notebook and you don’t see an image,
press the Source Search button on the projector or remote control
to select the image source.
NOTE: If you still see a blank screen or have other display problems,
see the troubleshooting tips on the back of this sheet.
2
To raise the image, press
the blue foot release
button for the front
adjustable foot and lift
the front. Release the
button to lock the
foot in position.
3
Turn the focus ring to sharpen the image.
Turn the zoom ring to reduce or
enlarge the image.
4
If your image looks like or , you’ve placed the projector off
to one side of the screen at an angle. Place it directly in front of the
center of the screen, facing the screen squarely.
5
If your image looks like or , press the or buttons
on the projector to correct it.
Adjust the image
CAUTION: Before unplugging the projector...
Shut down the projector properly:
1. Press the Power button twice.
2. When the orange light stops flashing and the projector beeps,
you can unplug the projector.
Turn over
Power light
Power button
Zoom
Focus
PL17001710_QS_CPD21954.indd 1 6/16/06 3:09:04 PM