INSTALLATION
HANDBOOK
Lamp and Status Information
Epson PowerLite 1750 / 1760W / 1770W / 1775W
3
7. Gently insert the new lamp into the projector. If it does not fit easily, make sure it is facing the right
way. Press down on the area shown to secure the lamp in place.
Caution: Do not touch any glass on the lamp assembly to avoid premature lamp failure.
8. Press the metal bar down over the lamp until it clicks into place on both sides.
9. Replace the lamp cover and tighten the screw to secure it.
Note: Be sure the lamp cover is securely installed or the lamp will not come on.
Reset the lamp timer to zero to keep track of the new lamp’s usage.
To Next Page
Loading...
Need help?
General