Making Detailed Adjustments 39
■ Block NR (Home Cinema 8700 UB only)
Note: This setting cannot be used when the Color Mode is set to x.v.Color (see page 28) or
with a signal input through the PC port.
This setting reduces block noise that can appear when projecting MPEG images that have
been compressed at a low bit rate.
■ 2-2 Pull-down (Home Cinema 8350 only)
Note: This setting can be used only when viewing a 1080p/24Hz signal input through the
Component, HDMI 1, or HDMI 2 ports (see page 67). This setting cannot be used when the
Color Mode is set to x.v.Color (see page 28) or with a signal input through the PC port.
This setting allows you to select whether images are projected with 2-2 pulldown
detection or 2-3 pulldown detection. Select
On for 2-2 pulldown detection.
■ 4-4 Pull-down (Home Cinema 8700 UB only)
Note: This setting can be used only when viewing NTSC, M-PAL, or PAL60 signals input
through the Video or S-Video ports, or 480i, 1080i/60Hz, or 1080p/24Hz signals input through
the Component, HDMI 1, or HDMI 2 ports (see page 67). This setting cannot be used when the
Color Mode is set to x.v.Color (see page 28) or with a signal input through the PC port.
This setting allows you to select whether images are projected with 4-4 pulldown
detection or 2-3 pulldown detection. Select
On for 4-4 pulldown detection.
■ Frame Interpolation (Home Cinema 8700 UB only)
This setting compares the current and previous frames, then creates a frame between
them to reduce fuzziness and produce clearer moving images. You can select from 3 levels
of frame interpolation.
Note: This setting cannot be changed while the 4-4 Pull-down setting is turned on.
Signal > Advanced > Block NR
Signal > 2-2 Pull-down
Signal > 4-4 Pull-down
Signal > Frame Interpolation
To Next Page
Loading...
Need help?
General