52 Maintenance
7. Gently tap both sides of the air filter against a hard surface
four or five times to remove loose dust from the air filter.
Note: Do not tap the filter too hard. This can cause it to bend
or break.
8. Use a small vacuum cleaner that is designed for computers
and other office equipment to remove any remaining dust
from the surface of the filter. If you don’t have one, gently
clean the filter using a very soft brush (such as a clean
artist’s paintbrush).
If the dirt is difficult to remove or the filter is broken,
replace it. You can purchase air filter part number V13H134A21 from an authorized
Epson reseller. To find the nearest reseller, please call 800-GO-EPSON (800-463-7766).
To purchase online, visit www.epsonstore.com (U.S. sales) or www.epson.ca (Canadian
sales).
9. Insert the air filter as shown with the groove on the right.
10. Reattach the air filter cover by inserting the tabs as shown and pressing the cover against
the projector until it clicks into place.
To Next Page
Loading...
Need help?
General