Page 4 of 5
PSB.2007.09.001
Settings Display
Uncheck the boxes for
the buttons that you do
not want to display in
Simple Mode.
Uncheck the boxes for the buttons
that you do not want to display in
Advanced Mode.
[3] How to set up EPSON Projector Control software
[Note] Be sure to set the projector to Network ON in Standby Mode in the Extended Menu.
1) Download “Epson12378.exe” from Epson website. This file contains
“ProjectorControlSetup.exe” which is used to install EPSON Projector Control for
Windows V.1.00 on the computer.
2) Set up your computer and the projector to connect over a network.
3) Start the EPSON Projector Control software as follows: “Start”Æ“Program”Æ“EPSON
Projector”Æ“Projector Control V1.00.” Then the main screen is displayed. Click
“Tool”Æ“Settings” on the main screen. The setting screen is displayed.
4) Enter the Projector IP Address, click “OK” to save, and close the setting screen.
To Next Page
Loading...
Need help?
General