3. Press the WirelessHD button on the remote control.
The WiHD light on the transmitter lights up and your projector displays WirelessHD content.
Note: If the WirelessHD connection fails, press the Setup button on the bottom of the WirelessHD
transmitter and try again.
Parent topic: Using WirelessHD
Switching WirelessHD Sources
If you have connected multiple HDMI input sources to your WirelessHD transmitter, you can use the
projector remote control to switch between sources.
1. Press the Input button on the remote control or the WirelessHD transmitter.
Note: Make sure to point the remote control at the WirelessHD transmitter.
You see this screen:
69
To Next Page
Loading...
