128 Maintaining the Projector
4. Loosen the two screws holding the lamp in place (you can’t
remove them).
5. Hold the lamp as shown and pull it straight out.
6. Gently insert the new lamp. (If it doesn’t fit easily, make sure it is
facing the right way.)
7. Once the lamp is fully inserted, tighten its screws.
Loosen, but don’t
remove these screws
note
The lamp(s) in this
product contain mercury.
Please consult your state and
local regulations regarding
disposal or recycling. Do not
put in the trash.
To Next Page
Loading...
