Epson PowerLite S17 - User Manual

To Next Page

INSTALLATION

HA NDBOOK

Maintenance

Epson PowerLite S17 / W17 / X17

Replacing the Lamp

Before you replace the lamp, let the projector cool down for at least one hour so the lamp will not be hot.

Warning: Let the lamp fully cool before replacing it to avoid injury.

You can replace the lamp while the projector is mounted to the ceiling, if necessary.

1. Turn off the projector and unplug the power cord.

2. Allow the projector lamp to cool down for at least one hour.

3. Use the screwdriver included with the replacement lamp to loosen the screw securing the lamp

cover.

Warning: If the lamp is broken, glass fragments may be loose inside the lamp chamber. Be careful

4. Slide the lamp cover out and lift it off.

removing any broken glass to avoid injury. If the projector is installed on the ceiling, stand to the side

of the lamp cover and not underneath it; pieces of glass could fall into your eyes or mouth when you

open the lamp cover.

Other manuals for Epson PowerLite S17

Need help?

Do you have a question about the Epson PowerLite S17 and is the answer not in the manual?

Steps for safely removing and replacing the projector lamp, including cooling and securing.

Instructions on how to reset the projector's lamp timer after replacement for accurate usage tracking.

General

Matrix type	3-panel (p-Si TFT active)
Number of colors	1.073 billion colors
Native aspect ratio	4:3
Projection distance	0.88 - 10.44 m
Projection technology	3LCD
Contrast ratio (typical)	10000:1
Screen size compatibility	- \
Projector native resolution	SVGA (800x600)
Keystone correction, horizontal	30 °
Focus	Manual
Throw ratio	1.45 - 1.96:1
Digital zoom	1.35 x
Focal length range	16.7 - 16.7 mm
Aperture range (F-F)	1.44 - 1.44
Lamp type	UHE
Lamp power	200 W
Lamps quantity	1 lamp(s)
Light source type	Lamp
Service life of light source	5000 h
Service life of light source (economic mode)	6000 h
3D	-
Full HD	No
Analog signal format system	NTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Audio (L/R) in	3
USB connector type	USB Type-A, USB Type-B
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Noise level	37 dB
Noise level (economic mode)	29 dB
RMS rated power	5 W
Placement	Desktop, Ceiling
Product type	Standard throw projector
Product color	White
Cable lock slot type	Kensington
Power source	AC
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	2.9 W
Power consumption (typical)	283 W
Power consumption (PowerSave)	234 W
Operating temperature (T-T)	5 - 35 °C
Sustainability certificates	RoHS
Cables included	VGA
Remote control type	IR