19
About the LED Indicators
Indicator status during normal operation
Orange
Standby
Press to start projection.
Green
Warm-up in progress
is unavailable for about 30 seconds.
Green
Projection in
progress
The projector is operating normally.
Indicator status during an error/warning
Red
Red
Red
Internal Error
Disconnect the power cable from the electrical
outlet, and contact Epson.
Red
Red
Fan Error
Sensor Error
Red
Red
High Temp Error
Wait for about ve
minutes, and then
disconnect the power
cable from the electrical
outlet.
Check the following points.
If the projectors are positioned next to a wall,
move them farther away from the wall.
Clean or replace the air lter.
Make sure nothing is blocking the vents.
•
•
•
Red
Orange
High Temp Warning
Red
Red
Lamp Error
Lamp Failure
Check the following points.
Remove the lamp and check that it is not
damaged. If it is not damaged, reinstall the
lamp and turn on the projector. If it is damaged,
contact Epson.
Check that the lamp and the lamp cover are
securely installed.
Clean the air lter.
•
•
•
Orange
Replace Lamp
Replace the lamp as soon as possible. The lamp
may fail if you continue to use it in this condition.
Red
Red
Red
Auto Iris Error
Power Error
Disconnect the power cable from the electrical
outlet, and contact Epson.Epson..
If the error continues to occur after checking the points above, disconnect the power cable from
the electrical outlet, and contact
Epson
.
The LED indicators change according to the status of the commander and the receiver. For more troubleshooting information, see your online User's Guide.
On Flashing O
To Next Page
Loading...
