Caution
Do not shake the ink bottles or maintenance box too hard.
Ink or waste liquid may leak from the ink bottles if you shake them too hard.
Do not disassemble the ink bottles or the maintenance box.
If it is disassembled, ink or waste liquid could get in your eyes or adhere to your skin.
If ink contacts your skin or enters your eyes or mouth, immediately take the following actions.
❏ If ink adheres to your skin, immediately wash it off using soap and water.
❏ If ink enters your eyes, rinse immediately with water. Failure to observe this precaution could result in bloodshot eyes or mild
inflammation. If you notice any problems or abnormalities at all, consult a physician immediately.
❏ If ink enters your mouth, consult a physician immediately.
Store the ink bottles and the maintenance box in a location out of reach of children.
Note the following points when refilling ink.
❏ Firmly tighten the caps of the ink bottles. Otherwise, ink could leak.
❏ Make sure ink does not leak when pouring ink into the inlet. Otherwise, ink may splash.
You may not be able to clean off ink that splashes onto clothes or belongings.
Do not drink the ink.
Do not rub the edges of the printing paper with your hand.
The edges of the paper are thin and sharp and could cause an injury.
Other Notes
❏ Be sure your power cable meets relevant safety standards of the area where you plan to use it.
❏ Do not put your hand inside this product or touch the printer head during printing.
❏ Do not put your hand inside this product or touch the white flat cable during printing.
SC-F500 Series General Information
Important Safety Instructions
9
To Next Page
Loading...
Need help?
General
