Epson Stylus CX3200 Software Installation

1
Installing Printer Software for
Macintosh
Connecting the EPSON Stylus CX3200
Before you start, make sure you set up your EPSON Stylus
®
CX3200 and installed
ink and paper, as described on the Start Here sheet. Then follow these steps to
connect the EPSON Stylus CX3200 to your Macintosh.
®
1. Remove the sticker from the USB port on the back of the Stylus CX.
2. Connect the square end of the USB cable to the USB port on the Stylus CX.
3. Then connect the flat end of the cable to a USB port on your Macintosh.
4. Follow the instructions in one of the next sections to install the printer
software on your Macintosh.
Flat end Square end

Epson Stylus CX3200 Specifications

General

Brand	Epson
Model	Stylus CX3200
Category	All in One Printer
Language	English