Epson Stylus CX3700 - Page 113

EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850 Revision A
DISASSEMBLY/ASSEMBLY Printer Section 113
4.4.12 ASF Unit
 External view (1)
Figure 4-21. Removing ASF Unit (1)
 Part/Unit
that should be removed before removing ASF Unit
Document Cover / Paper Support Assy. / Scanner Unit / Panel Unit /
Housing, Upper / Printer Mechanism
 Removal procedure
1. Peel off
the acetate tape (x1) that secures the PE Sensor Connector Cable to
the shield plate of the Main Board, and release PE Sensor Connector Cable
from the tabs (x3, ) of the ASF Unit and the Main Board Unit.
2. Release the CR Motor Connector Cable from
the tab (x1, ) of the ASF Unit.
3. Rem
ove the Ferrite Core of the PF Motor Connector Cable from the slot of the
ASF Unit.
4. Rem
ove the screws (x5, ) that secure the ASF Unit, and remove the
ASF Unit from the Printer Mechanism.
Tab
CR Motor
Connector Cable
Ferrite Core (PF Motor) and Slot
1
3
5
2
4
C.B.S. 3x6 F/Zn (8±1kgfcm)
C.B.S.(P2) 3x6 F/Zn (8±1kgfcm)
C.B.P. 3x8 F/Zn (4±1kgfcm)
Shaft and Slot
Front
Rib
Acetate
Tapes
Tabs
PE Sensor
Connector Cable
Shield Plate
Main Board Unit
ASF Unit
Guide Pin
ASF Unit
Ink System Unit
 Match the guide pin (x1, ) and the rib (x1, ) of the ASF Unit
with the positioning holes (x2) of the Main Frame.
 Insert the
shaft of the ASF Unit into the slot of the Ink System
Unit.
 Tighten the screws in the order as shown in the figure.