Epson Stylus CX3700 - Page 129

EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850 Revision A
DISASSEMBLY/ASSEMBLY Scanner Section 129
4.5 Scanner Section
4.5.1 Scanner Housing, Upper
 External view
Figure 4-41. Removing Scanner Housing, Upper
 Part/Unit
that should be removed before removing Scanner Housing, Upper
Document Cover / Scanner Unit
 Removal Procedure
1. Rem
ove the screw (x1, ) that secures the hinge R, and remove the hinge R
from the Scanner Unit.
2. Rem
ove the screws (x5, ) that secure the Scanner Housing, Upper.
3. Release the tabs
(x4, )) that secure the Scanner Housing, Upper, and
remove the Scanner Housing, Upper.
Document
Glass
Tab
Scanner Housing, Upper
C.B.P. 3x10 F/Ni
(7±1kgfcm)
Hinge R
C.B.P. 3x10 F/Zn
(5.5±0.5kgfcm)
C A U T I O N
 Following work should be performed in a room where there is a
little dust. A clean room or a clean bench would be preferable.
 Do not damage the document glass on the Scanner Housing,
Upper.
 Match the notch of the Scanner Housing, Upper with the tab
(x1,
) of the Scanner Housing, Lower.