Epson Stylus CX3700 - Page 145

EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850 Revision A
ADJUSTMENT Adjustment Except Adjustment Program 145
5.3.3 Original Adjustment
 Parts to be removed and replaced
 Replacement of Scanner Housing, Upper
 Replacement of Scanner Unit
 Adjustment procedure
1. Hold down the [Color Start] + [Paper Si
ze]+ [Fit to Page] and turn the printer
on. Keep pressing those buttons for five seconds, and the printer turns to the
scanner mode.
* This adjustment could be performed if turning on the printer without pressing
those buttons
, however, necessary time to transit to the ready mode becomes
shorter by following this approach.
2. Install “C592B00W.exe” to the computer,
and put the FT program into place.
Figure 5-15. Original Adjustment (1)
3. Open the document cover, and place the original adjustment jig
as shown in
the figure below.
Figure 5-16. Original Adjustment Jig
Setting Position
4. Open the FT, select “C592_PRN”on the “Select Param
eter Set” window, and
click [OK].
Figure 5-17. Original Adjustment (2)
C A U T I O N
 This adjustment requires the FT (Function Test) program and
the exclusive adjustment jig.
 If the setting of the printer differs from the one mentioned in the
following procedure, this adjustment could not be completed
correctly. In that case, the edge of the Scanner Housing, Upper
may be read in during scanning or copying.
exe file
FT
Pending
Place the jig against the upper left corner
of the Scanner Housing, Upper
Original Adjustment Jig