Epson Stylus CX3700 - Page 63

EPSON Stylus CX3700/CX3800/CX3805/CX3810/DX3800/DX3850 Revision A
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 63
Note : “–” : No change
Table 3-3. Error Indications and Fault Occurrence Causes
Printer Status Communication error Ink low Double feed Paper out
Indications
Power — — — —
Error — — On On
Ink — Blink Off Off
7-seg. — — — —
Paper Size
1 — — — —
2 — — — —
Fit to Page — — — —
Status monitor 3 message
Fault Occurrence Cause
This error is detected when the SPC
cannot communicate with the PC
correctly.
This error is detected when the ink
consumption amount reaches about
90%.
Note :
Even if this error is indicated on the STM3,
you can continue the printing until I/C
becomes Ink Out condition. However, the
Head Cleaning operation cannot be done so
that the remaining ink is low condition.
This error is detected at resending of
paper for double-sided printing when
paper length is determined to be other
than default value.
This error is detected when the top of a
paper is not detected with the PE
Sensor in the paper loading sequence.