24 Maintaining Your Epson Stylus CX
10. Close the scanner.
11. Press the
B ink button. The Epson Stylus CX begins charging ink and the
P
On light starts flashing. This takes about one minute. When it’s finished,
the P
On light stops flashing and remains on, and the B ink light goes out.
Caution:
Never turn off the Epson Stylus CX while the P On
light is flashing or you’ll waste
ink.
Note:
If the
B ink light stays on (not flashing), the ink cartridge may not be installed
correctly. Press the
B ink button again and reinstall the ink cartridge until it clicks
into place.
To Next Page
Loading...
