If ink-lacking light of the printer is flashing, it is aimed to remand you to change the cartridges. Press ink-changing button
Carriage move out Take out cartridges Press the ink-changing button again,
then you will find the cartridges are
full of ink. And you can print again.
Another reset method is: turn down the printer for one minute and then turn it on.
5. Refill Ink
Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the picture shown above, please use refill kits to fill
ink into Reservoir bottles. Carefully pull out the rubber plugs from the ink refill holes (There is possibility of ink spattering. Pls be careful.)
Refill ink according to the colors. Then re-cap the rubber. (Please keep the printer and the reservoir bottles at the same horizontal line
during the process of refilling ink.)
6. Attention for Maintenance:
Take out the CISS including the inner cartridges and other components. Then remove support arm from printer, and
re-install original cartridges. Please inquire local dealer before sending to maintenance.
7. Notice:
1. Please donāt take out cartridge at random after installing the CIS system. Keep the reservoir bottles on the same
level with the printer.