EPSON Stylus Photo 1200 Revision A
Adjustment Adjustment Program 21
5.2 Adjustment Program
Exclusive adjustment program is necessary in this section. This
interface improved user interfance and became easier to use than the
previous programs. Comparing with the adjustment of Stylus Photo750,
only modified or changed points are explained here.
5.2.1 Activatioin of Program
1. Turn off both printer and host computer, and connect them with
parallel interface cable.
2. Turn on the printer and host computer.
3. Make a folder in the host computer and save the file of adjustment
program in that folder. Or, insert the disk of the adjustment program
into the disk drive.
4. Run the program on the DOS Prompt of the Windows. The following
screnn (See Figure 5-2) will appear.
5. Select “Stylus Photo 1200” by using
↑↓ key and press “Enter” key.
Then, the screen for destination (See Figure 5-3) will appear.
Figure 5-2. First Screen of Adjustment Program
Figure 5-3. Destination Selection
Auto
Prom pt S P 751200
Auto
Prom pt S P 751200
To Next Page
Loading...
