c
Caution:
Always press the e ink cartridge replacement
button to move the print head. Do not move the
print head by hand. Doing so may damage the
printer.
While the ink is charging, the P power light
flashes and the printer produces a variety of
mechanical sounds. These sounds are normal.
When the ink delivery system has been charged, the print head returns
to the home (far right) position and the P power light comes on.
c
Caution:
Never turn off the printer while the P power light is flashing.
8. Close the printer cover.
Checking the printer
Before printing your first page, you need to make sure that the printer is
working correctly by loading paper, then printing a nozzle check page and,
if necessary, cleaning the print head. Refer to the section below.
Loading paper
Follow the steps below to load plain paper in the printer.
1. Lower the output tray and slide out the extension. Next, slide the left
edge guide so that the distance between the edge guides is slightly
wider than the width of your paper.
2. Fan a stack of paper, then tap it on a flat surface to even the edges.
3. Load the stack of paper in the sheet
feeder with the printable side up
and the right edge of the paper
resting against the right edge guide.
Then, slide the left edge guide
against the left edge of the paper.
Note:
❏ Always load paper into the sheet
feeder short edge first.
❏ Make sure that the paper stack fits under the arrow mark inside the edge
guide.
printable
side up
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
