Epson Stylus Photo P50 - Left & Right Guide Stackers; CDR Guide Sensor

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50 Revision C
Chapter 4 Disassembly/Assembly 4.4.7 Left & Right Guide Stackers / CDR Guide Sensor (Disassembling the Printer Mechanism) 81
Confidential
4.4.7 Left & Right Guide Stackers / CDR Guide Sensor
 Parts/Components need to be removed in advance
Printer Cover / Paper Support Assy / Upper Housing / Main Board Unit / Panel Assy /
Cover Open Sensor / Printer Mechanism
 Removal procedure
 Left / Right Guide Stacker Removal
1. Remove the screw and remove the Left Guide Stacker.
• Screw : C.B.P. M3x8 (tightening torque: 5-7 kgf.cm) (No.3)
2. Remove the screw and remove the Right Guide Stacker.
• Screw : C.B.P. M3x8 (tightening torque: 5-7 kgf.cm) (No.3)
Figure 4-64. Removing the Left / Right Guide Stacker
A D J U S T M E N T
R E Q U I R E D
Whenever the Waste Ink Pad is replaced, the required
adjustments must be carried out.
• Refer to "5.1.2 Required Adjustments" (p.107)
C A U T I O N
Be careful of the seven sharp edges shown in Fig.4-64 when
assembling or reassembling.
Left Guide Stacker
Left Guide Stacker
Right Guide Stacker
Sharp edge