Epson Stylus Photo PX650 - 4.4.11 Paper Eject Frame Assy

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635 Revision C
DISASSEMBLY AND ASSEMBLY Disassembling the Printer Mechanism 100
Confidential
4.4.11 Paper Eject Frame Assy
 Parts/Components need to be removed in advance
Upper Housing / Scanner Unit / Panel Unit / M/B Cover / Waste Ink Tray Assy /
Middle Housing / Printer Mechanism
 Removal procedure
1. Release the Head FFC from the Front Frame. (See Figure 4-86.)
2. Remove the screw that secure the Cable Holder Frame to the Front Frame. (See
Figure 4-87.)
3. Remove the screws (x2) that secure the Front Frame, and remove the Front Frame.
Figure 4-94. Removing the Paper Eject Frame Assy (1)
 Install the PG Left Cam by mating the D cut surfaces and with
the cam positioned outside so that it does not come in contact
with sensing area of the APG Sensor
.
Figure 4-92. Installing the CR unit (2)
 Install the CR Unit so that the guide is engaged with the frame.
Figure 4-93. Installing the CR unit (3)
 When installing the Cable Holder Frame, make sure that it is
positioned correctly in the front and back direction. (Fig. 4-87)
A D J U S T M E N T
R E Q U I R E D
 After removing/replacing the CR Unit, make the specified
adjustments. (See Chapter 5 "ADJUSTMENT".)
 After replacing the CR Unit, be sure to perform the required
lubrication. (See Chapter 6 "MAINTENANCE".)
With the cam
positioned outside
PG Left Cam
APG Sensor
Must not touch
the sensing area
Rear
Carriage guide
C.B.S. 3x6 (8±1 Kgfcm)
2
1
Front Frame
Protrusion