Epson Stylus Photo PX650 - Page 146

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635 Revision C
Epson Stylus Photo PX660/PX660 Premium/Artisan 635 Disassembly/assembly 146
Confidential
4. Peel off the acetate tape, and release the all cables and FFCs of the Scanner Unit
from the grooves and ribs of the Middle Housing.
5. Pull out the Scanner FFC from the Ferrite Core A.
Figure 8-3. Removing the Scanner Unit (2)
6. Pull out the hinge of the Scanner Unit on the left side.
7. While keeping the Scanner Unit open at 45 degrees, push it in the direction of the
arrow as shown in Fig. 8-4 to remove the Scanner Unit from the right hinge.
Figure 8-4. Removing the Scanner Unit (3)
Acetate tape
Ferrite Core A
Groove and Rib
Double-sided tape
C H E C K
P O I N T
If you remove the Upper Housing using the L-shaped screwdriver,
the stubby driver or a similar tool (p.66), the Scanner Unit is
secured with the screws. Make sure to remove the screws (x2) that
secure the Scanner Unit before taking the following steps. (See
Figure 4-11.)
Scanner Unit
Groove
Rib
Right
Hinge
Hinge
Left
Hole