Epson Stylus Photo R360 - Error and Warning Indications; Error Indication Method

EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Troubleshooting Error/Warning Indications 33
3.2 Error/Warning Indications
This section describes how the printer indicates an error/warning status with the LCD
and LEDs, or on the screen of the printer driver when a problem arises during various
operations; power-on sequence, paper feeding, ink drawing, printing, and so on.
3.2.1 Error Indication Method
The Stylus Photo R360/R380/R390 are equipped with a LCD. You can solve most of
the troubles following the instructions shown on the LCD or on the windows of
“EPSON Status Monitor 3”.
 Stylus Photo R360/R380/R390
Error messages are displayed on the LCD.
• Figure 1-1. "Difference in Appearance"(p.9)
 Stylus Photo R260/R265/R270
Error messages can be checked with the LEDs and on the windows of “EPSON
Status Monitor 3”.
• Figure 1-5. "Stylus Photo R260/R265/R270"(p.20)
Table 3-3. LEDs Status (R260/R265/R270)
• Message box on the window of "EPSON Status Monitor 3"
Figure 3-2. Error Indication on EPSON Status Monitor 3
NOTE: The part number of the Ink Cartridges shown in the Status Monitor 3
screen differs by destination.
LED Status Meaning
-- No change
Light Lights up normally
Flash Flashes at intervals of 0.5 seconds.
Flash 2 Flashes as follows; ON (0.2 sec.) - OFF (0.2 sec.) - ON (0.2 sec.) - OFF (0.4 sec.)
Flash 4 Flashes as follows; ON (0.8 sec.) - OFF (0.2 sec.)
High-speed flash Flashes at intervals of 0.1 seconds.
Message Box