EPSON Stylus Photo R260/R265/R270, R360/R380/R390 Revision B
Disassembly/Assembly Removing Control Boards 79
3. Remove the four screws. (For R260/R265/R270, three screws only)
• Screw (3 pcs.): C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)
• Screw (1 pc.): C.P. M3x6 (tightening torque: 7-9 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
4. Remove the Main Board. (R260/R265/R270 only)
Figure 4-54. Removing the Main Board (1)
5. Remove the Main Board, taking extra care not to get the FFC caught on the
opening of the CB Support Shield Plate. (R360/R380/R390 only)
Figure 4-56. Removing the Main Board Unit (2)
C A U T I O N
The MB Frame deforms easily. Exercise care not to deform it while
removing the Main Board.
Figure 4-55. Cautions on Removing the Main Board Unit
1
R360/R380/R390
3
2
4
R260/R265/R270
2
3
Main Board
MB Frame
Removal Direction
Opening
Main Board
CB Support
Shield Plate
To Next Page
Loading...
