14 Making Prints From Your Digital Camera
Scanning the index sheet and printing
1. Place the index sheet face-down on the document
table, in the upper left corner, so that the top of the
sheet is aligned against the left edge of the
document table.
2. Close the document cover.
3. Load the type of paper you want to use (& page 4).
Load enough sheets for the number of photos you
want to print.
4. Make sure the Print from Index Sheet light is on.
5. On the control panel, select the paper type and the
paper size that you loaded.
6. Press the x Start button to start printing.
Note:
❏ If you need to stop printing, press the y Stop/Clear
Settings button.
❏ If you have more than one index sheet, wait for the EPSON
STYLUS PHOTO RX to finish printing. Then repeat the
steps above to scan and print from each additional sheet.
7. When you are done printing, remove the memory
card by pulling it straight out of its slot.
Selecting Auto Correct
With auto correct you can make adjustments to your
photos using the P.I.M. or Exif data on your camera,
or by using the PhotoEnhance setting.
* These options are automatically selected when your pictures
contain P.I.M. or Exif data.
1. Press the Setup/Utilities button.
2. Use the l or r button to select auto correct, as
shown below.
3. Press the x Start button to confirm your selection.
4. Use the u or d button to select the mode.
Top
Bottom
Setting Description
OFF Prints with no automatic correction.
P.I.M.* Prints using the PRINT Image Matching
function. If the photo data does not include
P.I.M., try printing with PhotoEnhance.
PhotoEnhance Prints enhanced photos automatically. It
requires longer time, but gives better
quality.
Exif* Prints using the Exif Print function. It
provides you with high-quality printouts.
To Next Page
Loading...
