1 Open the scanner lid and remove the yellow sticker. Then unlock
the scanner as shown.
Note: You can store the film holder in the scanner lid behind the
white document mat.
2 Lift open the scanner section to access the printer area.
3 Remove the orange print head lock and store it as shown.
Epson Stylus
®
Photo RX620
Star t Here
1 Plug your Stylus Photo RX620 into an electrical outlet, then press the
O n button. The green light comes on and the ink cartridge holder
moves to the left.
2 Open the ink cartridge holder.
3 Remove the ink cartridges from their packages
4 Insert each ink cartridge, then press it down so it clicks into place.
5 Close the ink cartridge holder, then close the scanner section.
Install Ink Cartridges
4
1 Open the output tray.
2 Flip the feeder guard forward and slide the edge guide to the left.
3 Place a stack of paper against the right side of the sheet feeder.
Slide the edge guide lightly against the left side of the paper.
5 Press the O K button to start ink charging. Wait about 2 minutes
until charging completes.
1 Make sure you have all the parts shown here. If any parts are missing,
contact Epson
®
as described on the back of this sheet.
2 Remove all the blue packing tape from the Stylus Photo RX620.
Caution: Do not remove the yellow stickers until instructed.
3 Insert the paper support.
4 Connect the cable.
Unpack and Assemble
Turn over
1
5
Load Paper
Unlock
2
Paper support
Software
CD-ROM
Quick Guide
Epson Stylus Photo RX620
Ink cartridges
(6 total)
Film and slide holder
CPD-18568
Printed in XXXXXX XX-XX.XX XXX
continue
On button
Press
OK button
1 Remove the yellow sticker over the USB port and plug the square
end of your USB cable into the port, as shown below.
Caution: Do not connect the cable to your computer until you
have installed the software.
Connect the Cable
3
2 Route the cable in the channel along
the side of the RX620, as shown.
Edge guide
CPD18568_Patt_SH_E.qxd 9/3/04 3:49 PM Page 1
To Next Page
Need help?
Printer Specifications
