Epson Stylus Photo T60 - Power Problems; Ink-Related Problems

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50 Revision C
Chapter 3 Troubleshooting 3.4 Troubleshooting by Symptom 49
Confidential
3.4.2 Power Problems
The printer does not work at all after power-on. LEDs do not light up.
3.4.3 Ink-related Problems
 Printer stops halfway through its initialization process or printing operation.
Table 3-17. Troubleshooting Power Problems
Possible Cause Check Point Remedy
Power code failure Replace the power code with a new one. Does the printer work normally? The power code is defective. Use the new one.
Improper power supply
Do the power supplied from the AC line match with the electrical
requirements of the printer?
Use an AC line that matches the printer electrical requirements.
Poor connection of the PS Assy connector Is the PS Assy connector not properly connected to the Main Board? Connect the connector properly.
The fuse burned out Is the fuse (F1) on the PS Board burned out? Replace the PS Board.
Abnormal voltage output of the PS Board
Check the voltage output from the PS Board. Is it abnormal? When the voltage is normal: Replace the Main Board.
When the voltage is abnormal: Replace the PS Assy.
Table 3-18. Troubleshooting Ink Supply Problems
Symptom Possible Cause Check Point Remedy
An Ink Out error occurs. The cartridge is empty. Is the ink cartridge empty? Replace the cartridge with a new one.
A No Cartridge error
occurs.
The printer cannot detect
the ink cartridge.
Are ink cartridges not installed in the IC Holder? Install ink cartridges.
Are the ink cartridges not properly installed? Set the cartridges properly.
Are the top and bottom tabs of the ink cartridge broken? Replace the cartridge with a new one.
An ink cartridge error
occurs.
Ink cartridge is damaged.
Is the CSIC Board not properly attached? Replace the cartridge with a new one.
Is there any chipped or broken elements on the CSIC Board? Replace the cartridge with a new one.