Epson Stylus Photo T60 - Page 88

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50 Revision C
Chapter 4 Disassembly/Assembly 4.4.12 CR Motor (Disassembling the Printer Mechanism) 88
Confidential
3. Release the connector cables from the three hooks, then peel off the three
acetate tapes to release the CR Motor cable.
Figure 4-84. Removing the CR Motor (2)
4. Insert a Phillips screwdriver (with a shaft of 13cm or longer is recommended)
through the hole of the Front Frame, remove the two screws, and remove the
CR Motor.
• Screw : C.P. M3x4 (tightening torque: 3-5 kgf.cm) (No.6)
(The numbers shown in the figure indicate the order of tightening the screws.)
Figure 4-85. Removing the CR Motor (3)
C A U T I O N
When assembling or disassembling the CR Motor, be careful of the
three sharp hooks of the Main Frame shown in Fig.4-84.
: Hook
CR Motor
CR Motor Cable
[Rear Side]
1
2
CR Motor
 When routing the CR Motor Cable and PE Sensor Cable, refer
to Fig.4-86 and follow the steps below.
1. Wrap the CR Motor Cable with the acetate tape A (30 mm)
at the position of 100 mm away from the acetate tape that is
on the CR Motor side.
2. Tie the two cables together with the acetate tape B (20 mm)
at the position 60mm/40mm away from the acetate tape A/
PE Sensor connector.
3. Route the center of the acetate tape A behind the convex
portion of the Main Frame, and secure the tied cables with
the hook (1) at the center of the acetate tape B so that the
CR Motor Cable faces toward you.
4. Wrap the CR Motor Cable and PE Sensor Cable with
acetate tapes (20 mm) at the positions of the hooks (2) (3),
then secure the center of the acetate tapes with Hooks (2)
(3).
Figure 4-86. Routing the Cable
: Hook
PE Sensor
1
0
0
m
m
(
b
e
t
w
e
e
n
b
o
t
h
e
n
d
s
o
f
a
c
e
t
a
t
e
t
a
p
e
s
)
6
0
m
m
(
b
e
t
w
e
e
n
b
o
t
h
e
n
d
s
o
f
a
c
e
t
a
t
e
t
a
p
e
s
)
P
E
S
e
n
s
o
r
C
a
b
l
e
4
0
m
m
(
f
r
o
m
c
o
n
n
e
c
t
o
r
t
o
e
n
d
o
f
a
c
e
t
a
t
e
t
a
p
e
)
2
3
Convex
Portion of
Main
Frame
A
CR Motor
B1