1-18
1-18 | Setting Up the Printer
4. Check
Share this Printer
, then type a name for the printer and
password information as needed.
5. Click
OK
. The name of the shared printer appears in the port list in the
Chooser.
6. Close the Chooser.
Configuring the Client Macintosh Computers
Perform these steps on every Macintosh that will need to access the printer:
1. Open the Chooser, click the printer’s icon, and then select the shared
printer name on the right. You can only select from the printers
connected to your current AppleTalk zone.
2. If you’re prompted for a password, enter the password for the printer
and click
OK
.
3. Make sure
Background Printing
is turned off. Then close the Chooser.
For instructions on using your printer software, see Chapter 3.
Note
To avoid unnecessary
spooling, background
printing should be turned
off for all client
computers.
To Next Page
Loading...
