1
Slide the removable paper stop off the left end of
the spindle.
To use a 3-inch roll paper core, attach the gray
adapters to the paper stops at each end. See
your
Printer Guide
for details.
2
Position the roll paper as shown, then slide it onto
the spindle.
3
Slide the removable paper stop back onto the
spindle and insert it firmly into the end of the roll.
7
Move the paper lever to the released position.
8
Feed the paper into the slot and pull it all the way
through.
1
4
Open the roll paper cover on the printer.
5
Place the roll paper in the printer as shown. (The
white end of the spindle goes on the right.)
6
Make sure the printer is turned on, then press the
Paper Source button until the Roll Auto Cut
light comes on.
To avoid feeding excess paper, make sure you
don’t select Sheet when you’re using roll
paper.
9
Turn the roll back to
remove any slack. Then
align the bottom edge of
the paper with the row of
holes, as shown.
10
Return the paper lever to the locked position,
then close the roll paper cover.
11
Press the Pause button. The paper feeds into the
printing position automatically and READY
appears on the control panel.
To Next Page
Loading...
