Epson Stylus Pro 7710 - Page 119

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
TROUBLE SHOOTING Remedies for Error Messages 119
Confidential
44 NOZZLE CLOG DETECTED
NOT ENOUGH INK
CONTINUE CLEANING?
YES (RECOMMENDED)
NO
There is not enough ink to perform cleaning. By clicking YES, the message to replace the ink cartridge appears.
Replace the ink cartridge with a new one to continue cleaning.
45 NOZZLE CLOG DETECTED
NOT ENOUGH EMPTY SPACE
IN MAINT TANK
CONTINUE CLEANING?
YES (RECOMMENDED)
NO
There is not enough space in the maintenance tank to
perform cleaning.
By clicking YES, the message to replace the maintenance tank appears.
Replace the maintenance tank with a new one to continue cleaning. (See
P.208)
46 TAKE-UP DISCONNECTED
SET AUTO TAKE-UP REEL SYSTEM IN
PRINTER AND RESTART THE PRINTER
Auto Take-up Reel Unit is not correctly installed in the
printer. Auto Take-up Unit is disconnected when the printer
is turned on.
Turn the printer off, and then install the Auto Take-up Reel Unit
properly.
Auto Take-up Reel Unit is not recognized. Replace the USB cable.
Replace the Main Board Assy or the Auto Take-up Reel Unit. (See
P.228, P.313)
47 TAKE-UP DISCONNECTED
AUTO TAKE-UP REEL UNIT IS DISCONNECTED
DO YOU CONTINUE?
NO
YES
Auto Take-up Reel Unit is not correctly installed in the
printer. This occurs at power-on, the Auto Take-up Reel
Unit was connected the last time the printer was on.
Select NO, and turn the printer off, and then install the Auto Take-up
Reel Unit properly. If you select YES, the paper is ejected without
using the Auto Take-up Reel Unit.
Auto Take-up Reel Unit is not recognized. Replace the USB cable.
Replace the Main Board Assy or the Auto Take-up Reel Unit. (See
P.228, P.313)
48 TAKE-UP ERROR
CHECK THE STATUS OF AUTO TAKE-UP REEL
UNIT AND RESTART THE PRINTER
The roll paper is not set to the Auto Take-up Reel Unit
properly.
Press the button to release the paper presser, and then set the roll
paper to the Auto Take-up Reel Unit properly.
49 TAKE-UP ERROR
IS ANYTHING OBSTRUCTING THE TAKE-UP
REEL SENSOR SYSTEM?
LOAD PAPER AGAIN
The Auto Take-up Reel Unit does not wind the paper. Check if there is some foreign material stuck on the sensor or the
reflector plate of the Auto Take-up Reel Unit, or some interruption of
the light by an obstacle.
50 SProofer DISCONNECTED
CONNECT SpectroProofer TO THE PRINTER
AND RESTART THE PRINTER
The SpectroProofer is not connected to the printer properly. Turn the printer off, and then connect the SpectroProofer to the printer
properly.
51 ILS20EP DISCONNECTED
REFER TO THE MANUAL AND CONNECT
ILS20EP TO SpectroProofer
RESTART THE PRINTER
The color measurement device (ILS20EP) is not connected
properly.
Turn the printer off, and then connect the color measurement device
(ILS20EP) to the SpectroProofer properly.
No. Message on LCD Description Remedy/Points to be checked