Epson Stylus Pro 7710 - Page 197

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly Flowchart 197
Confidential
CARRIAGE MECHANISM
NOTE * : Maintenance Tank L is only for Epson Stylus Pro 9700/9710/9900/9910/9890/9908.
START
“4.4.2.1 Control Panel” (p203)
“4.4.2.4 IC Cover (L/R) & IC Shaft
Cover (L/R)” (p206) (R only)
“4.4.2.6 Maintenance Tank (L/R)”
(p208) (R only)
“4.4.2.7 Right Cover” (p209)
“4.4.1.1 Unlocking the Carriage
Unit manually” (p201)
“4.4.4.3 CR HP Sensor” (p239)
“4.4.4.6 APG Motor” (p243) “4.4.4.1 CR Scale” (p236)
“4.4.4.2 CR Encoder Sensor”
(p238)
“4.4.2.6 Maintenance Tank (L/R)”
(p208) *
“4.4.2.1 Control Panel” (p203)
“4.4.2.7 Right Cover” (p209)
“4.4.2.8 Left Cover” (p211)
“4.4.4.5 CR Motor” (p242)
“4.4.4.4 Driven Pulley Unit” (p240)
“4.4.2.10 Top Cover” (p214)
“4.4.4.7 APG Unit” (p244)
“4.4.2.4 IC Cover (L/R) & IC Shaft
Cover (L/R)” (p206)
“4.4.1.1 Unlocking the Carriage
Unit manually” (p201)
“4.4.6.1 Ink System Unit” (p266)
“4.4.4.4 Driven Pulley Unit” (p240)
“4.4.4.7 APG Unit” (p244)
“4.4.4.9 Carriage Unit” (p248)
“4.4.6.3 Printhead” (p270)
“4.4.4.1 CR Scale” (p236)