Epson Stylus Pro 7710 - Page 244

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 244
Confidential
4.4.4.7 APG Unit
1. Remove the Control Panel. (p203)
2. Remove the IC Cover R and the IC Shaft Cover R. (p206)
3. Remove the Maintenance Tank R. (p208)
4. Remove the Right Cover. (p209)
5. Remove the IC Cover L and the IC Shaft Cover L. (p206)
6. Remove the Maintenance Tank L. (p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
7. Remove the Left Cover. (p209)
8. Remove the Top Cover. (p214)
9. Unlock the Carriage Unit and move it to the center. (p201)
10. Remove the three screws that secure the Plate A, and remove the Plate A.
A) Silver, Phillips, Bind machine screw M3x6: three pieces
11. Remove the nine screws that secure the Plate B, and remove the Plate B.
B) Silver, Phillips, Round Washer Head S-tite M3x6: two pieces
Figure 4-71. Removing the Plate A
Figure 4-72. Removing the Plate B
C A U T I O N
In the next step, after removing the Plate B the Main Frame will
drop and its weight may apply an extra load to the Carriage Unit.
Therefore, make sure to hold the cover or remove the Front Cover
(Middle) in advance. (p207) Removing the Front Cover (Middle)
will make the frame lighter and avoid extra loading to the Carriage
Unit.
A
APG Unit
Plate A
B
Plate B