Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
ADJUSTMENT Tests 431
Confidential
MOUNTER ONLY TEST’S PROCEDURE
Preparation
1. Start the inspection program.
2. Connect the mounter to the computer with a USB cable.
3. Turn on the mounter.
NOTE:
When the computer recognizes the mounter a wizard screen is
displayed, click on the [Cancel] button.
4. Select MOUNTER ONLY TEST from the inspection program.
Figure 5-89. [MOUNTER ONLY TEST] Menu Screen
Sensors check
1. Select Sensors check from the inspection program.
2. When the following screen appears, remove the mounter from the printer.
(It is OK to detach the right side of the mounter from the printer slightly.)
Figure 5-90. [Sensor check] Screen
3. Click on the [OK] button.
4. Confirm the blue screen appears, click on the [OK] button.
Figure 5-91. Confirmation Screen
To Next Page
Loading...
