176
176 | Maintaining and Transporting the Printer
2. Tighten the screw using a cross-head screwdriver.
3. Align the cover, then press it in until it clicks into place.
4. Press
OK to finish the replacement process. The cutter moves to home
position.
5. Run the Cutter Adjustment from the Maintenance Menu on the control
panel.
After you print the pattern, put the two cut pieces together and select
the pattern with the most precise cut between the two colors. Select the
pattern number on the control panel and press
OK.
Note: Reinstall the
optional SpectroProofer if
necessary, following the
instructions that came
with it. Then turn on the
printer and press the OK
button.
To Next Page
Loading...
