4-10
4-10 | Resolving Problems
•
Make sure the
Print Mode
or
Media Type
setting is correct for the
media you’re printing on.
•
Make sure the platen gap setting is correct for the paper or media you’re
printing on. See page 1-17 for more information.
•
If you’re not using EPSON media, make sure you register and select
your paper’s thickness. See page 1-22 for more information.
Solving Roll Paper Feed Problems
If your roll paper is curled too tightly and doesn’t feed out of the printer, you
can use the three paper guides. Extend the guides as shown below:
•
If you have the paper hammock set up in front of the printer, extend the
paper guides out so they rest on the front of the hammock.
Caution
Use the paper guides only
if paper is curled and
doesn’t feed properly.
Otherwise, the paper
guides may damage
your prints.
To Next Page
Loading...
