93
Maintaining and Transporting the Printer | 93
3. Use the d and u buttons to select the settings described below. If you
need to back up to the previous menu level, press l.
• To change the language on the LCD display, press d to highlight
LANGUAGE, then press r. Press d until you see the language you
want, then press
OK to select it. The printer exits maintenance
mode and returns to normal operation.
• To change the units of measurement, press d to highlight LENGTH
UNITS
, then press r. Press d to switch from METRIC to
FEET/INCH, then press OK to select it. Press l when done.
• To change the temperature units of measurement, press d to
highlight
TEMPERATURE UNITS, then press r. Press d to switch
from
C (Celsius or centigrade) to F (Fahrenheit), then press OK to
select it. Press
l when done.
• To change the maximum roll paper tension, press d to highlight
ROLL PAPER TENSION, then press r. Press d to decrease the
maximum value, or u
to increase it (from 1 to 5). The default
setting is 3. Press
OK to select the setting you want.
• To run a super strong cleaning cycle, press d to highlight
SS CLEANING, then press r to display EXECUTE. Press OK to
start the cleaning cycle.
• To return all control panel settings to their default values, press d to
highlight
DEFAULT PANEL, then press r to display EXECUTE.
Press
OK to restore the default settings.
• To change the number of times the printer cleans the print head
after it performs a nozzle check and finds blocked nozzles, press d
to highlight
AUTO CLEANING TIMES, then press r. Press u to d
to change the setting (from 1 to 3), then press
OK to save the
setting. The default setting is 1 (recommended).
4. To exit maintenance mode, turn off the printer by pressing the P power
button. Press the P power button again to turn on the printer in the
normal operating mode.
Note: The CUSTOM
setting in maintenance
mode is not normally
used.
To Next Page
Loading...
